03 GT first time dyno
 

Took my car for its and my first dyno ever since ive always been curious to see what my actual numbers were. I'll try to get the graphs on here Soon but the car made 308.7HP @3700RPM and 490.6TQ @2900RPM on its first pull. The torque is WAY OFF but ill go with it :jester:
Run 2 was 304.7/485.5
Run 3 was 300.7/461.3

Humidity was at 50% and it was also 98.8 degrees!

Not trashing your numbers but your hp is off too. HP readings are a direct calculation of the torque readings. So if the torque numbers are off with the dyno, than the whole thing is a wash because it can't calculate HP either. Did C.A.M dyno it?

Aside from that, unless you were spraying nitrous on the pulls, there is no way a 2v car can put down that much HP with the mods in your sig.

Again, I am not being a jackass. Just trying to help you out. Whoever dyno'd it, needs to refund your money or give you some more pulls when they get the machine fixed

Yep, the load calculations are way off on that dyno. :yup:

Sadly the car will probably sold before i can take it to reputatle shop i figured i would of seen 270ish.

How much is 3 pulls there?

It was 50$ but normally i have no clue how much it cost.

:agree: Especially on the bolded part. Those torque numbers are in modded Lightning/Terminator territory.

Did they do the dyno pull in 4th gear? :shrug:

Just thinking maybe a 3rd gear pull skewed the numbers way out of line.

where did u take it?

You know what kind of dyno they use?