Recommendations on vacuum caps & hoses
 

Can anyone make a recommendation? It seems like every other month I have to replace the vacuum caps on my Turbo Coupe. I been using OE style rubber and they just seem to crack and fall apart too often. Thanks!

Just use vacuum hose and bolts or sticks!:jester::jester:

have you tried the assorted caps you can get your local parts store?

Yeppers... (The rubber ones anyway) They all just disintegrate after a couple months. Interesting thing though, it's the caps on the vacuum tree. The caps & hoses that are right there at the wastegate never seem to have any problems. I have seen the "multi-colored" poly/plastic lookin ones at the parts store, but I seem to recall them not being very flexible. Another thing I also have to do is either hose clamp or zip tie the caps on because at 18 psi they tend to blow off - even if they're on real snug.

I would recommend golf tees


actually I was going to say try using a worm clamp on them if you can get one on them.

You need a check valve on the line that feeds the vac tree?or pvc is stuck open or vac lines could be routed incorrect.jmo

Check lines routing just in case.Here is routing for #1 stock boost controller and #2 if you have the gillis type.:dunno:

This is how I would try it.Tee the boost gauge and controller to the intake vac source as to keep them working proper.Then install pcv in the main line so it will not allow boost to back track through the vac tree..jmo thinking outside the box.:shrug: Also the gas vapor from vapor canister from the tank can and will deteriorate hoses.

Those are the ones to get. I got tired of the rubber ones dry rotting all the time, and switched to the vinyl colored ones, and haven't had any problems with them. Theyre flexible enough, and last forever.:nice:

I think my routing is fine - but I might try this & see what happens.

Thanks Eric!