View Single Post
Old 11-15-2010, 11:11 AM   #1
redhorse
Senior Member
 
redhorse's Avatar
 
Join Date: Jul 2005
Location: Trussville, Al
Posts: 819
Send a message via Yahoo to redhorse
Stall issue with 03 Mach 1

I can't make this happen and it only happens occasionally.

Most of the time when turning left from a stop. Ease out of the clutch into the throttle. The car starts to roll and then stalls, with dashes appearing on the odometer. Coast to a complete stop, turn the switch completely off and start the engine. Engine starts with no problem at all and the car runs fine. Like I said at first, it mainly happens when starting and making a left turn. It has happened twice when starting in loose gravel in a straight line.

Tac Bear put his Diablo Programmer on it and it showed no codes, any ideas.

When making a U-turn or a hard left turn at times the car wants to stumble under acceleration. I have been told that it is possibly a wheel sensor that is going bad.
__________________
Mean Little Man

Last edited by redhorse; 11-15-2010 at 11:15 AM.
redhorse is offline   Reply With Quote