![]() |
![]() |
#1 |
Senior Member
Join Date: Jan 2008
Location: sand mountain
Posts: 463
|
![]()
I've done the 5 lug swap and done all new suspension
I put the EIBACH pro kit , cc plates from upr, and new struts and shocks (kyb) My problem is that the driver side wheel is a rubbing bad on the outer fender. I measured from the frame to the strut on both sides of the car and the driver side is sitting out a little over an inch more the the passenger side. I'm stumped I can't figure out why it would do this maybe because I haven't gotten a front end alignment yet? I need feed back please thanks Rob
__________________
1990 lx 302 w/trickflow intake, b-303 cam, tremec 3550 ,spec stage 3 clutch, crane 1.7 rockers, under drive pulleys, bbk full length headers, and x-pipe,3:73 gear. AND....... ![]() |
![]() |
![]() |
![]() |
#2 |
BamaMafia 4 Life
Join Date: Feb 2005
Location: Lake View, AL
Posts: 2,577
|
Assuming that everything has been installed correctly, my first thought is the cc plates and the need for an alignment.
__________________
1999 Ford F-150 Lariat |
![]() |
![]() |
![]() |
|
|