power window ?

Catang5oh · 09-29-2006, 05:37 PM

well, i should have known they had been into these wires also. heres my issue, drivers side window works fine, passenger side will not work at all from the driver side control, but on the pass side control it will go down, not up. if i jump the rd/bk and y/bk wire on pass side it goes up and down just fine. already swapped the switches around and they all work the same everywhere. the schmatic shows a power window control module, does anyone have an idea where it is located.

any help is greatly appreciated

thanks

SkurdalenFox · 09-30-2006, 08:45 AM

I assume this is the 1990? If so, here's another wiring diagram that may be of use.
http://i84.photobucket.com/albums/k3.../window001.jpg

Check to make sure you're getting power into the master control switch for the passenger window.

Also, make sure the connector for the switch is not corroded/fouled up, and is making a proper connection.

I'm going to bet it's just a bad connection at the switch. Those things can be really finicky. I had a door lock switch that looked connected but for some reason, wasn't making a connection. Drove me nuts.

09-29-2006, 05:37 PM	#1
Catang5oh Senior Member Join Date: May 2005 Location: Between the A and the T Posts: 365	power window ? well, i should have known they had been into these wires also. heres my issue, drivers side window works fine, passenger side will not work at all from the driver side control, but on the pass side control it will go down, not up. if i jump the rd/bk and y/bk wire on pass side it goes up and down just fine. already swapped the switches around and they all work the same everywhere. the schmatic shows a power window control module, does anyone have an idea where it is located. any help is greatly appreciated thanks

09-30-2006, 08:45 AM	#2
SkurdalenFox Senior Member Join Date: Sep 2005 Location: Boulder, CO Posts: 463	I assume this is the 1990? If so, here's another wiring diagram that may be of use. http://i84.photobucket.com/albums/k3.../window001.jpg Check to make sure you're getting power into the master control switch for the passenger window. Also, make sure the connector for the switch is not corroded/fouled up, and is making a proper connection. I'm going to bet it's just a bad connection at the switch. Those things can be really finicky. I had a door lock switch that looked connected but for some reason, wasn't making a connection. Drove me nuts. __________________ Jim