Project Quiet Cobra - Phase One Complete (*DUW*)

[FastRedPonyCar]

Looks good. I too am enjoying the cheap and extremely effective B-quiet stuff. When I put my new door speakers in, I bought a roll and covered the doors. Went on very easily but I had to use brake parts cleaner to clean the scissors X_x That black adhesive rubbery tar stuff that it uses to stick was super sticky. There's no way that stuff is coming off.

I ended up not using the roller because it had trouble going through the bends and crevacies. I just used my fingers to press it in along the ridges and it worked great. There were two huge holes in the inner layer of sheetmetal where you can see the side impact beam and window on the inside of the door. After covering that road noise is significantly dropped and the mysterious breeze that found it's way through the door handle on the inside of the car is now gone.

I also lined the speaker mounting hole with the B-quiet stuff to avoid any rattling. I orginally had just put the speakers in using the mounting brackets that the factory speakers used but they rattled the door. So I pulled the bracket and mounted it on the bquiet and that took care of it. Sounds amazing and when I shut the door it's a quiet thump. Very solid. Not quite as solid as my dad's 540I but pretty stinkin close.

I'd like to do the rest of the car like you did nate but I don't have the time to do something like that right now. It'd be feasible to do it incrimentally like do the trunk area one weekend then mabey the front part another. Definately a better way to go rather than dynamat. That junk is WAAY overpriced.