StreetStangs.net  

Go Back   StreetStangs.net > Technical > Dyno Room

Reply
 
Thread Tools Display Modes
Old 04-08-2007, 03:46 PM   #11
QWKSNKE
3v's are slow
 
QWKSNKE's Avatar
 
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
Quote:
Originally Posted by qkjuicedpony View Post
how much timing is in it?
I was wondering that as well. Did you notice the curve on Crzpny's at 5400 or so. Shouldn't it have kept going up or at least stayed flat and then fall at 6k rpm. I figure the tfs intake would flow better than my cobra in the upper rpm
__________________
2009 Porsche Carrera S
2008 ///AMG C63.. Eurocharge Tune. RIP
2019 AMG GLC43..wife's
03 F250 SD.. Edge Evo, AFE Stage 1 CAI
08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's
01 Cobra vert... wife's

I need a new toy

Last edited by QWKSNKE; 04-08-2007 at 03:49 PM.
QWKSNKE is offline   Reply With Quote
Old 04-08-2007, 04:13 PM   #12
1sicklx
BamaMafia 4 Life
 
1sicklx's Avatar
 
Join Date: Feb 2005
Location: Lake View, AL
Posts: 2,577
It is the TFS kit minus the cam as the car already had a Bcam installed and we didn't swap them ... the spacer was used due to valve cover clearance.

Timing prior the tuning was set at 14 deg. I don't know what the timing/fuel pressure was at after Doug tuned it.
1sicklx is offline   Reply With Quote
Old 04-08-2007, 04:20 PM   #13
qkjuicedpony
Dayuuuuuuum!!!!!
 
qkjuicedpony's Avatar
 
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
get rid of the 1.6's and put 1.7 rockers on it.and add a little timing and some fuel
__________________
86 Mustang Gt......Mods piling up in my garage.

07 F350 dooly.....Tows my fifth wheel
qkjuicedpony is offline   Reply With Quote
Old 04-08-2007, 04:56 PM   #14
Crzypny
Senior Member
 
Crzypny's Avatar
 
Join Date: Aug 2005
Location: Hoover, Al
Posts: 576
Quote:
Originally Posted by qkjuicedpony View Post
how much timing is in it?
Quote:
Originally Posted by 1sicklx View Post
It is the TFS kit minus the cam as the car already had a Bcam installed and we didn't swap them ... the spacer was used due to valve cover clearance.

Timing prior the tuning was set at 14 deg. I don't know what the timing/fuel pressure was at after Doug tuned it.
Fuel pressure was set at 32lbs and if I am not mistaken the timing was set at 15 deg.

I am curious however about if the "B" cam is affecting overall performance potential. I used the same h/c/i using the trick flow cam in my '89 GT and it dyoned at 249hp with an automatic tranny.
Crzypny is offline   Reply With Quote
Old 04-08-2007, 05:12 PM   #15
QWKSNKE
3v's are slow
 
QWKSNKE's Avatar
 
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
I doubt the b cam is hurting it. I made 295rwhp with a b cam and 1.7 rockers.

EEC tuning should have been done with fuel press at 39 psi (vacuum off) and base timing set at 10 degrees.
What qkjuiced and are referring to, in regards to timing, is how much timing is in the car at WOT. Should be in neighborhood of 35-40 degrees depending on what the car combo likes.
For example, in my current combo my car did best at 34 degrees timing at WOT.
QWKSNKE is offline   Reply With Quote
Old 04-08-2007, 05:15 PM   #16
qkjuicedpony
Dayuuuuuuum!!!!!
 
qkjuicedpony's Avatar
 
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
i do know that the 94-95 processors can act a little crazy but i had the same combo in the same car without a chip.the only adjustments made were with timing and fuel and it made over 300.


how many miles are on the motor and does it use any oil,also are the rockers stud mount or pedestal mount?
__________________
86 Mustang Gt......Mods piling up in my garage.

07 F350 dooly.....Tows my fifth wheel
qkjuicedpony is offline   Reply With Quote
Old 04-08-2007, 05:29 PM   #17
Crzypny
Senior Member
 
Crzypny's Avatar
 
Join Date: Aug 2005
Location: Hoover, Al
Posts: 576
Quote:
Originally Posted by QWKSNKE View Post
What qkjuiced and are referring to, in regards to timing, is how much timing is in the car at WOT. Should be in neighborhood of 35-40 degrees depending on what the car combo likes.
For example, in my current combo my car did best at 34 degrees timing at WOT.
The numbers I quoted for fuel pressure and timing were not WOT - those are where he set them at idle.

Car has approx 150k miles on it. Not sure exact number as my odometer quit at 147k. No oil used.
Crzypny is offline   Reply With Quote
Old 04-08-2007, 05:31 PM   #18
qkjuicedpony
Dayuuuuuuum!!!!!
 
qkjuicedpony's Avatar
 
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
the car is a 5 speed right?
__________________
86 Mustang Gt......Mods piling up in my garage.

07 F350 dooly.....Tows my fifth wheel
qkjuicedpony is offline   Reply With Quote
Old 04-08-2007, 05:36 PM   #19
Crzypny
Senior Member
 
Crzypny's Avatar
 
Join Date: Aug 2005
Location: Hoover, Al
Posts: 576
Quote:
Originally Posted by qkjuicedpony View Post
the car is a 5 speed right?
Crzypny is offline   Reply With Quote
Old 04-08-2007, 05:39 PM   #20
QWKSNKE
3v's are slow
 
QWKSNKE's Avatar
 
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
Quote:
Originally Posted by Crzypny View Post
The numbers I quoted for fuel pressure and timing were not WOT - those are where he set them at idle.

.

yeah I know. The 39 and 10 I referred to is the preferred settings at idle when EEC tuning
__________________
2009 Porsche Carrera S
2008 ///AMG C63.. Eurocharge Tune. RIP
2019 AMG GLC43..wife's
03 F250 SD.. Edge Evo, AFE Stage 1 CAI
08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's
01 Cobra vert... wife's

I need a new toy
QWKSNKE is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:24 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.